Supported CNC Routers within Cabinet Pro and Door Pro
Cabinet Pro supports all CNC routers that use Woodwop, Biesseworks, TPACad, Hops, Wincut, Xylog, or any variation of g-code. Because Cabinet Pro's post processor is user-defined, the CNC code can be greatly modified, if necessary. So if different commands are needed, or if commands need to be ordered in a different sequence than is part of the already existing post processors listed below, this can be done very easily within Cabinet Pro (or Door Pro). We will work with someone of your choosing, who is familiar with the g-code necessary to run your machine, and within a very short time will have your g-code output matching the specific requirements of your CNC router.
Some CNC Routers supported by Cabinet Pro and Door Pro
(Please note: Cabinet Pro LLC does not endorse any particular router. Those shown below are listed here for informational purposes only.)
Cabinet Pro CNC and Door Pro CNC writes any variation of g-code to routers that are or are not listed below, as well as code directly to BiesseWorks, Hops, Woodwop, TPACad, and Xylog (See Below).
Please Note: If your CNC router requires code that is unique or slightly different from the posts listed above, we may need to modify an already existing Post Processor for your specific machine. This is a relatively simple task and will be done at no additional charge, as long as you are willing to help test the modifications, and the changes are not extensive.
WoodWop (Weeke & Homag)